How to Flush a Warren Water Heater

Posted by on Jan 17, 2014 in Water Heater Repair Warren MI

Ok, so it is not an attractive water heater upkeep task, however it does need a little cleaning up from time to time. Yes, today Water Heater Repair Warren MI is going to advise one on ways to eliminate a water heater. Some suggest doing this when every one to three years, we feel it is best to do so as soon as a year. Doing so is not a difficult or time consuming project – heck, let the kids aid even.

Why Flush a Warren MI Water Heater?

If it is last the advised life expectancy of the unit, it should have some sort of routine flushing done. Doing so will obviously assistant in having it run as successfully as possible, which also means saving money on the cost of running the darn thing. That alone ought to be a sufficient reason we feel!

In terms of water heater maintenance, flushing it will do away with the buildup of mineral deposits that natural occurs inside the water tank. If one has ever had loud noises, popping, gurgling, mini-explosion sounds, that is an indicator that there is too much sediment inside the tank. This flushing procedure will help see to it that the tank warms water a lot more quietly.

Step 1. If it is an electric water heater, turn the power off in the primary electric breaker box and turn the cold water supply off. If it is a gas heater, it is ok to leave the gas on – simply turn the water off. Though, turn the thermostat setting dial to the pilot setting (make a note to remember exactly what it was initially set at though for later on). Then, whichever faucet the water heater supplies is closest requires to be opened. This is generally much easier than opening the pressure relief valve, but one can do that instead.Water Heater Repair Warren MI

Step 2. At the bottom of the water heater is a drain valve that a garden watering hose can be attached to. There might be a cover over it depending upon the maker. Think about turning the heat to the pilot setting a number of hours prior to flushing it if one wants so the water isn’t going to be as hot when it is drained. If that is not an option that’s fine, just make sure the garden hose made use of is in good shape to endure the greater temperature water.

Run the hose outside far from your home or if the water has already cooled, one can drain the tank into buckets.

Step 3. Open the water heater’s drain valve and begin draining the water. For whatever reason the drain valve is usually made of plastic, so if one has an older water heater (and one that has actually not been drained since before time started) it may stick a little. Just be mindful to not break the plastic (which is why it would be nice if the darn thing was NOT made from plastic).Water Heater Repair Warren

Once the drain valve is open, likewise open the pressure relief valve on the heater. Water will (at least it must if it pressure relief valve is working effectively) stream some from it. Try to let is flow stable and not too fast so it stirs up the sediment in the water heater. We want the sediment to drain out the bottom through the hose.

If draining in a container, even if having the hose drain into a bucket beyond the garage or basement where the water heater is found, fill a bucket and let it sit to see if the water is clear or if there is sediment, which will typically look like sand in the bottom of the bucket. Just keep draining it till the water is clear.

Step 4. Close the drain on the bottom of the storage tank and close the pressure relief valve if it is still open.

Step 5. Turn the water supply on again to fill the tank. As soon as it is full once more, slowing open the pressure relief valve once more to get some excess air out of the tank. Then, open a hot water faucet in the house to obtain even more air out of the system.

Step 6. Let the hot water in the bathtub run till a complete stream is streaming out. Once that occurs, it is ok to turn the power back on if it is an electric water heater, or reset the temperature setting for a gas water heater. Certainly, turn the bathtub faucet off. In about 20 minutes, the hot water ought to be heated up once again.

There you go! Water Heater Repair Warren MI is here to address any concerns you could have. Next take have a look at our article on what to do if one has no hot water.

Enhanced by Zemanta